| MCSE习题——基础知识（3） |
|
|
作者：网友 文章来源：不详  |
31:
You are designing a WAN connect 3 networks locate in chicago, Atlanta andlos Angeles
desired result:
all of computer on each of 3 network must be able to communication with any other computer on the 3 networks
the WAN link must be capable oftransmising data at a minimum speed of 1 Mbps
optional results:
.you want to provide continous communication when 1 link failure
.you want to provide continuous communication when 1 link failure at minimum 1Mbps
proposed solution:
connect 3 networks using 2 primaryT1 and 2 secondary asynchronous 9600 bps link as shown below
figure 1
A: match results andmatch all optional
b: match results and one of optional
c: match resultsand none of optional
d: not match results
ans:b
32:
you are designing a WAN connect 3 networks locate in chicago, Atlanta andlos Angeles
desired result:
all of computer on each of 3 network must be able to communication with any other computer on the 3 networks
the WAN link must be capable oftransmising data at a minimum speed of 1 Mbps
optional results:
.you want to provide continous communication when 1 link failure
.you want to provide continuous communication when 1 link failure at minimum 1Mbps
proposed solution:
connect 3 networks using 16 port RAS server at each location , as shown in exhibit
each port will have a 28.8 modem
figure 2
A: match results andmatch all optional
b: match results and one of optional
c: match resultsand none of optional
d: not match results
ans:d
33:
you are design disaster prevention and recovering plan .
network config:
server : 2 ,total run windows NT server
one is PDC , another is BDC
client : 100 ,all run windows 95
network type : 10BaseT
You done following .
place all confidential data on server.
place server on a locked room.
implement NTFS user-level security on servers to share resouce
desired results:
.you must prevent server form hardisk failure ,however period of down time of less than 2 hours areacceptable
.you must have resonable controls in place to protect network data from loss
optional:
.you want to trace all access of data
.you want to put reasonable methods in place to protect network data from virus corruption
proposed solution:
.connect UPS to each server
.set proper access-control security on shared resources
.implement disk striping with parity fro each server's hardisks
.do daily tape backup of data,store tape in a off-site location
.implement virus scanning on all clients and servers
.enable audit on shared file
which result?
a: match results and both of optional
b:match results and one of optional
c:match results and none of optional
d:not match
ans:a
34:
you want to monitor network performance and faciliatetrouble shooting of network problems.
which tool should you use?
a: cable tester
b: volt-ohmmeter
c: TDR
d: protocol analyzer
ans:d
35:
You want communication on your network to continue even if one of you server's hardisk fails, you also want to limit costs
which type ?
a:RAID 0
B: RAID 5
C: duplexed hard disks
D: backup file server
ans:b
36:
The server on your network run NT server,the network use TCP/IP
the network is devided with routers into multiple subnet
what can enable client to browse netbios name on all subnet of the network ?
a: a WINS server
b: a DHCP server
c: a router
d: a NETBIOS broadcast
ans:a
37:
You want to monitor and manage the hubs , bridges , routers in you network, your server run NT server,
which should you include in your plan?
a: performance monitor
b: SNMP management station:hardware;
c: protocol analyzer
d: TDR
ans:b
38:
You install a server network card, run NT server , the computer has com1,com2,lpt1,lpt2,network card
use I/O address 300 , IRQ 3
which conflict ?
a:vga card
b:com1
c:com2
d:lpt1
ans:c
39:
You install a network card in a client , the computer's software is initial success,but the computer not able to communication with other computers on the network , all other client computers on the network are able to communication.
what is the most likely cause of problem?
a: the transceiver setting of the network adapeter is incorrect
b: I/O address
c: cablle segment not properly terminator
d: packet-size setting is incorrect
ans:d? a
40:
Which tool should you use to messure network utilization?
a: protocol analyzer
b: TDR
c: cable tester
d: volt_ohmmeter
ans:a
41:
You install category 5 UTP for new 100Mbps network
which tool should you use to test the bandwith:sfotware: of cabling?
a: protocol analyzer:sfotware:
b: TDR
c: volt-ohmmeter
d: performace monitor in NT
ans:a
42:
There are 78 places, 50 to 100 computers in each location , the client computers run various operating system , include windows for workgroupand windows 95 , the employee turn over tate is high.
what should you include in you security plan?
a:centralizion manage user account , user-level share management
b:centralizion manage user account , resource passwordshare management
c:peer to peer file sharing with resouce password security on all shared resoures.
d:peer to peer file sharing with use level security management
ans:c? a
**43:
what must you ensure that a netbios name does not duplication? ( choose 3)
a: another computer name on the same network
b:another domain name on the same network
c:another workgroup name on the same network
d:another share name on the same network
ans:abc
44:[1] [2] 下一页
|
| 声明：本站所发表的全部或部分内容仅代表个人观点，与本站无关，谢谢合作！ |
|
上一篇电脑： MCSE习题——基础知识（2）
下一篇电脑： MCSE习题——基础知识（4） |
用户登录 
新用户注册 
